®
Lytecaster Recessed Downlighting
1000LVE
Page 1 of 1
5" Aperture Electronic Low Voltage MR16 Incandescent Frame-In Kit
Complete Fixture consists of Reflector Trim & Frame-In Kit. Select each separately.
Frame-In Kit
Reflector Trims — See Individual Reflector Trim Specification Sheets
Adjustable
Baffles
Aperture Cone
Pinhole
Elbow
1000LVE1
120V- 0.67A Max
1055LV
1055WHLV
1056LV 1064WDLV
1063LV 1064WDPLV
1064LV
1052LV
1062LV
1000LVE2
277V- 0.27A Max
1064CDLV
Features
Options & Accessories (continued)
1. Mounting Frame: .036" (#20 ga.) galvanized steel. Accommodates all
ceilings up to 1" thick; including existing or inaccessible areas. Breakout
section and anchor nails permits installation in existing ceilings from below.
Push-in/twist-out rotoclips hold reflector flush to ceiling.
Plaster Ceiling Ring:
Extra-Thick Ceiling
Mounting Ring:
1960 - 7/8" depth for wet plaster ceilings.
1967B - up to 2" thick ceilings.
MR16 Socket Replacement:
Remodeler Anchor Clip:
1975B
1985N
2. Junction Box: 4" x 3 1/2”x 2", .063" (#14 ga.) galvanized steel. U.L. listed for
maximum of 8 No. 12 ga. 90° C through branch circuit conductors (1000LVE2
only). Integral cable clamps permit attachment of nonmetallic Romex® or
armored cable without need of additional connectors.
Labels
UL (Suitable for Damp Locations), I.B.E.W.
3. Mounting Bars: .059" (#16 ga.) galvanized steel. 13" long bars extend
to 27" with integral nailing tabs. Attaches to wood joist without need of
accessories.
4. Socket Housing: .036" (#20 ga.) galvanized steel.
5. Socket: Field replaceable. Two pin socket, pre-wired with #18 SF1 leads to
junction box.
6. Thermal Protector: Meets NEC and UL requirements. Insulation must be
kept 3" away from fixture sides and wiring compartments and must not be
placed above fixture in a manner which will entrap heat.
7. Transformer: Outboard mounted, Electronic, 120V (1000LVE1), 277V
(1000LVE2)primary, nominal 12V secondary. Removable from below.
Romex® is a registered Trademark of General Cable Industries Inc.
Job Information
Type:
Job Name:
Cat. No.:
Lamp(s):
Notes:
Dimming
Dimming Controls: Use only dimmers specifically designed for use with elec-
tronic transformers. Consult Lightolier Controls for more information. Low volt-
age luminaires may produce audible sound when used with dimmers, which may
be objectionable in acoustically critical areas.
Options & Accessories
631 Airport Road, Fall River, MA 02720 • (508) 679-8131 • Fax (508) 674-4710
We reserve the right to change details of design, materials and finish.
Mounting Bars:
1964 - 20" set of (2)
1956 - set of (4)
T-Bar Ceiling Clips:
Lightolier is a Philips group brand
|
Land Pride Snow Blower RBT55120 User Manual
Leviton Stereo System 48211 6A User Manual
LG Electronics Indoor Fireplace RDV3340 User Manual
Magnadyne Laptop Docking Station MV VS2 User Manual
Makita Cordless Drill 6012HD User Manual
Makita Impact Driver 6918FD User Manual
M Audio DJ Equipment Torq User Manual
Maxfield MP3 Player 6GB User Manual
Maytag Ventilation Hood LI3VQA User Manual
Maytag Washer MAV5000 User Manual